This section describes how to access the web interface of the Pinebox over an Ethernet connection.
To power the Pinebox, apply 24V to the power connector. The Power LED will turn green and the Pinebox will start. For further details, please refer to the Power Connection section.
For the Ethernet connection, there are different options on how to establish the connection. The following image shows the most common configurations:
If the connection is established over an existing network infrastructure (router), the IP address for the Pinebox is usually assigned by the DHCP server in the network from a pre-defined IP range. In this case, the user needs to determine the IP address on the configuration page of the router.
The web interface of the Pinebox can be accessed by typing http:/aaa.bbb.ccc.ddd into the address line of your web browser, where aaa.bbb.ccc.ddd is the assigned IP address. Alternatively, the devicename of the Pinebox can be used. The devicename is compiled from the serial number, a device with serial number 12345 will have the devicename pinebox-12345. The address for the Pinebox web interface is then http://pinebox-12345
The connection from the PC to the router can be either wired or wireless.
The direct connection can be established either via the PC’s build-in Ethernet connection or via a USB-to-Ethernet adapter:
After establishing the connection, the adapter needs to be configured. The following images show how this is done in the Windows operating system.
> Settings



